Allo RemoteControl NICE HSKIT2GWFR Інструкція - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція для Система безпеки Allo RemoteControl NICE HSKIT2GWFR. Allo RemoteControl NICE HSKIT2GWFR 3 сторінки. Alarm system set

Друкувати сторінку

Programming an intrusion detector:

01. Select the zone to assign the detector to: "Alarm zone A", B, C, D, E, F.

02. Select the detector: touch "Add 1 detector".

03. Fill out all fields as follows: Delay: Touch "Delay" and enter the alarm delay (0 Sec = alarm

is sent immediately). This delay gives the user time to enter the home and disarm the alarm

without tripping the detector. Confirm with "OK". Name: Touch "Name" and enter the detector's

name (e.g.: "kitchen"). Confirm with "OK". Voice name: Touch "Voice name" and record the

name of the detector (e.g.: "kitchen").

04. Confirm with "OK".

05. Touch "OK" again and fit the battery into the detector. The control panel beeps to confirm

(3 beeps indicate that the detector is already present). 06. Press "OK" to save the settings

Programming a 24H Technical detector:

The procedure associates a technical detector (i.e., flooding, smoke, etc.) to the control panel.

This type of detector must be programmed into the "24H Technical" group. This group is always

armed.

01. Select "24H Technical".

02. Select one of the programmable detectors and press "Add".

03. Fill out all fields in the following page as follows: Name: Touch "Name" and enter the

detector's name (e.g.: "kitchen smoke"). Confirm with "OK". Voice name: Touch "Voice name"

and record the name of the detector (e.g.: "smoke").

04. Confirm with "OK".

05. Touch "OK" again and fit the battery into the detector. The control panel beeps to confirm

(3 beeps indicate that the detector is already present). - HSDIW01 (flooding sensor): this must

be connected to the HSDID11 by cable;

Programming the touch screen:

Further to the main touch screen, others can be added up to a total of 4 units.

- Select touch screen. - Select one of the 4 Touch screens not yet assigned and press "Add".

- Fit the batteries into the new touch screen.

- On the new unit, touch and scroll with , then select "Union" .

- On the new unit, touch "New union" and confirm with "OK".

- Confirm with "OK" on the main touch screen and the list will now include the new unit.