Allo RemoteControl NICE Era TOUCH HSTS2FR Інструкція
Переглянути онлайн або завантажити pdf Інструкція для Сенсорний екран Allo RemoteControl NICE Era TOUCH HSTS2FR. Allo RemoteControl NICE Era TOUCH HSTS2FR 4 сторінки.
Друкувати сторінкуINSTRUCTIONS
NICE HSTS2FR Era TOUCH Touchscreen
To perform the initial start-up proceed as follows (fig. 3):
01. Open the lid: press on point 1 and then push the bottom upwards (point 2);
02. Check that memory board A is there; if not insert it in the suitable slot (point 3);
03. Insert the batteries, observing the polarity shown (point 4);
04. Replace the bottom.
Visit our Website. www.alloremotecontrol.com
Upon start-up, the main screen appears on the display (fig. 4) which has three icons
from where you can access the respective sub-menus.
To browse through the menu and the sub-menus, just touch the screen in
correspondence to the desired icon.
Various screen models are available as well as several browsing icons. Before
proceeding, get familiar with the screens and icons by consulting figures 4 and 5. Note
– Some of the icons in this manual are only visible if the HSTS2 is used as an interface
to control the HSCU2 series alarm control units. The icons associated with scenarios or
command groups are shown below by way of example. The icons related to scenarios
or command groups will be displayed only if associated during the configuration.
Visit our website: www.Alloremotecontrol.com
families: