AllPondSolutions PF-8000 Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Системи фільтрації води AllPondSolutions PF-8000. AllPondSolutions PF-8000 19 сторінок. Pressurised pond filter, bio-mechanical filtration, built in steriliser, large filter volume, pressurised closed system, simple user friendly operation

Друкувати сторінку

TROUBLESHOOTING

UV Indicator is not Lighting Up

If the UV indicator on the top of the ﬁlter lid is not lighting up follow these

troubleshooting steps:

1. If you ﬁnd that the UV light is not operational, check that you have power

from the mains supply.

3. If you do have power from the mains supply, clean the UV indicator. Check if

you can see the UV is operational through the

viewing hole on top of the unit. If you aren't able to

see it, try performing a safety override. Locate the

safety override switch on the ballast end next to

the UV bulb ﬁtting (as shown in the image on the

right).

IMPORTANT!

NEVER look directly at the UV light.

Press and hold the small thin silver switch when

the power is on and the bulb should ignite. Please

test in a dark/ shadowed place and do not look directly at the bulb – we

recommend covering the bulb with kitchen roll or similar. You should still be

able to see the glow of the bulb through this.

4. If the above does not solve the issue replace the UV bulb.

5. Please check for signs of damage or water ingress to quartz sleeve and bulb

area. You might need to replace your quartz sleeve and/or O-Ring if that's the

case.

6. If you ﬁnd that the UV light is still not operational after the bulb replacement,

the UV ballast may have developed a fault and you will need to contact the

supplier of your unit to obtain replacement parts.

Please remember that UV bulbs for use in ponds should be replaced every 12

months.

Slow Flow Rate

1. Rinse unit's foams making sure they are free of debris.

2. Ensure that the inlet hose connecter has been cut correctly to size, if not

this will restrict the ﬂow from the pump into the ﬁlter.

3. Ensure that the inlet hose is not kinked or crushed.