AllPondSolutions FPP-2000 Посібник - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник для Водяний насос AllPondSolutions FPP-2000. AllPondSolutions FPP-2000 16 сторінок. Fountain eco pond pump
Друкувати сторінку
INSTALLATION & USE
The All Pond Solutions FPP pump range is designed to be used with the
included fountain kit as a standalone system within a pond but can be used to
circulate water, pump to and from a separate filtration system or water features
using suitable flexible hose (flexible hosing sold separately).
Please read the below instructions carefully before beginning to set up your
pump. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
1. Connect the required
attachments - Choose the required
attachments. Depending on the
model you can choose between 3-4
different fountain styles.
2. Position the unit - fully submerge
your FPP unit. Place it on a level and
sturdy surface at the bottom of your pond, this is to avoid silt entering the pump
causing excessive wear and increasing pump guard cleaning.
3. Adjust the fountain head - make sure it is above surface of the pond. Adjust
the extendable pipe until desired height has been achieved.
Adjust the flow rate by turning the flow adjuster clockwise to increase it and
anti-clockwise to reduce it.
Adjust ball joint to compensate for an uneven pond floor if necessary.
IMPORTANT!
Ensure that the pump's fountain does not empty water out of
pond.
4. Connect your FPP pump to the mains - Connect the unit to the mains using
a residual current device (RCD) for additional safety.
5. Switch on your unit at the mains - turn on the operation by switching on the
unit at the mains.