Miller 300360001 Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller 300360001. Miller 300360001 17 сторінок.

Друкувати сторінку

1. Troubleshooting

10. GTAW Connections

To prevent overheating, make sure cooling

unit is positioned so there is 12 in. (305

mm) of unrestricted airflow on sides of unit.

NOTICE − If welding power source has a

water valve, do not connect hoses to water

valve. Connect hoses as shown.

Coolant Out Hose

Coolant In Hose

Fittings have 5/8-18 left-hand threads.

Connect hoses with proper fittings as

shown. Some power sources may require

a TIG block.

Coolant Tank Cap

115 Or 230 Volt AC Grounded Re-

ceptacle (Depending On Model)

NOTICE − Do not cut plug from 115 volt

cord and attempt to rewire for 230 volts, or

do not cut plug from 230 volt cord and at-

tempt to rewire for 115 volts.

For 115 volt models, an individual branch

circuit capable of carrying 15 amperes and

protected by fuses or circuit breakers is

recommended. Recommended fuse or cir-

cuit breaker size is 15 amperes. For 230

volt models, an individual branch circuit ca-

pable of carrying 10 amperes and pro-

tected by fuses or circuit breakers is rec-

ommended. Recommended fuse or circuit

breaker size is 10 amperes.

Tools Needed:

11/16 in.

Operation:

You may experience pump/priming

noise during initial start-up, or after

changing or replacing coolant.

Fill tank with proper coolant. Use table in

Section 9 to select proper coolant. Maintain

coolant level at approximately 1 in (25 mm)

below top of filler neck. Connect hoses as

shown. Unit turns on when plugged in and

power switch is turned on.

For correct water cooled torch ad-

apters, see Parts List or the Coolmate

Series Options And Accessories

page.

OM-235 464 Page 5

805 189-B