Miller Axcess 300 Посібник користувача - Сторінка 25
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller Axcess 300. Miller Axcess 300 44 сторінки. Arc welding power source and wire feeder with meters
Також для Miller Axcess 300: Посібник користувача (36 сторінок), Посібник користувача (48 сторінок)
Друкувати сторінку
5-4. Changing Drive Roll and Wire Inlet Guide
.045 Groove
.035 Groove
Stamped
.035
Tools Needed:
5/64 in
7/16 in
5-5. Removing Knob From Front Panel
3
2
Stamped
.045
3
2
1
5
1
6
4
4
1
1
Securing Screw
2
Inlet Wire Guide
Loosen screw. Slide tip as close to
drive rolls as possible without
touching. Tighten screw.
3
Anti-Wear Guide
Install guide as shown.
4
Intermediate Guide
5
Drive Roll
.
The drive assembly comes
equipped with fractory installed
.035/.045 combination drive
rolls. Be sure that all 4 drive
rolls are installed correctly.
Combination drive rolls consist of
two different sized grooves. The
stamped markings on the end sur-
face of the drive roll refers to the
groove on the opposite side of the
drive roll. The groove closest to the
carrier gear is the groove for the
wire size viewed on the end surface
of the drive roll.
Install correct drive roll for wire size
and type.
6
Drive Roll Securing Nut
Turn nut one click to secure drive
roll.
802 520-A
Y Turn Off power.
1
Front Panel
2
Knob
3
Slot
4
Control Shaft
Rotate knob to allow access to slot.
Insert tip of screwdriver into slot,
and while pushing on spring clip,
pull knob off control shaft.
To reinstall, push knob fully onto
control shaft.
803 346
OM-1321 Page 21