Miller Gold Seal 422 Посібник користувача - Сторінка 21
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller Gold Seal 422. Miller Gold Seal 422 37 сторінок. Arc welding power source and wire feeder
Друкувати сторінку
5-7. Troubleshooting Table
Trouble
No weld output; wire does not feed; fan
does not run.
does not run
No weld output; wire does not feed; fan
motor continues to run.
No weld output; wire feeds.
Low weld output.
Electrode wire feeding stops during
welding.
welding
Secure power cord plug in receptacle (see Section 3-1).
Replace building line fuse or reset circuit breaker if open.
Secure gun trigger plug in receptacle (see Section 3-2).
Place Power switch in On position (see Section 4-1).
Thermostat TP1 open (overheating). Allow fan to run; thermostat closes when unit has cooled (see
Section 2-2).
Check and replace motor fuse F1, if necessary (see Section 5-3).
Have Factory Authorized Service Agent check all board connections and shut down PC1 board.
Connect work clamp to get good metal to metal contact.
Replace contact tip (see Section 5-5).
Check for proper polarity connections (see Section 3-3).
Connect unit to proper input voltage or check for low line voltage.
Place voltage switch in desired position (see Section 4-1).
Straighten gun cable and/or replace damaged parts.
Adjust drive roll pressure (see Section 3-6).
Change to proper drive roll groove (see Section 5-2).
Readjust hub tension (see Section 3-5).
Replace contact tip if blocked (see Section 5-5).
Clean or replace wire inlet guide or liner if dirty or plugged (see Section 5-2 or Section 5-6).
Replace drive roll or pressure bearing if worn or slipping (see Section 5-2).
Secure gun trigger plug in receptacle or repair leads (see Section 3-2).
Check motor fuse F1, and replace if necessary (see Section 5-3).
Check and clear any restrictions at drive assembly and liner (see Section 3-6 or Section 5-6).
Have nearest Factory Authorized Service Agent check drive motor.
Remedy
OM-187 926 Page 19