Miller XR-Pistol-Plus Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller XR-Pistol-Plus. Miller XR-Pistol-Plus 32 сторінки. Air and water-cooled guns
Друкувати сторінку
5-5. Threading Welding Wire Through Gun
!
Welding wire is electrically live when
gun trigger is used to jog wire.
.
Turn OFF coolant supply before removing
head tube on water-cooled gun.
Tools Needed:
OM-248663 Page 10
Refer to wire feeder manual for instructions on
feeding wire through feeder.
1
Lay gun cable out straight. Press Jog switch
until about 6 in. (152 mm) of wire is sticking
out end of contact tip.
Cut off wire. Close and latch
wire feeder door.
1
Pressure Arm Lever
.
To release drive roll pressure,
pull back on pressure arm lever.
While pulled back, shift to left
onto shoulder to lock into place.
.
Verify pressure adjustment
on handle matches the wire
type. See Section 6-2.
Ref. T0001-A / T0005-A