Miller XR-W Aluma-Pro Plus 25 Посібник користувача - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальна система Miller XR-W Aluma-Pro Plus 25. Miller XR-W Aluma-Pro Plus 25 36 сторінок. Air and water-cooled guns
Друкувати сторінку
5-5. Threading Welding Wire Through Gun
For XR-Aluma-Pro Plus Gun:
!
Welding wire is electrically live when
gun trigger is used to jog wire.
.
Turn OFF coolant supply before threading wire
through gun..
Tools Needed:
Cut off wire. Close and
latch wire feeder door.
Refer to wire feeder manual for instructions on
feeding wire through feeder.
JOG / PURGE
Lay gun cable out straight. Press Jog switch until about 6
in. (152 mm) of wire is sticking out end of contact tip.
.
Verify pressure adjustment
on handle matches the wire
type. See Section 6-2.
Ref. 285542-A / 285543-A
OM-285555 Page 11