Miller ArcStation 60SX Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Зварювальне приладдя Miller ArcStation 60SX. Miller ArcStation 60SX 16 сторінок.
Друкувати сторінку
F. Installing Bottom Trays
AA and ZZ
EE and ZZ
Tools Needed:
hex bit 3/16 in.
G. Rotating Welding Table Upright
OM-244997 Page 8
AA and ZZ
1/2 in.
!
Use two people to rotate
welding table.
It is recommended that a piece of
cardboard be placed on the floor to
prevent damaging the finish on the
end subframes. Rotate the welding
table on its side as shown.
.
Install shelves so that the wider
flange is on the end subframe
and the narrower flange is on
the center subframe.
Use four bolts AA and four locknuts
ZZ to install shelves to bottom
brackets of the center and end
subframes.
Use two bolts EE and locknuts ZZ
to fasten trays to the center
subframe.
Tighten all bolts and locknuts.
Proceed to Subsection G.
!
Use two people to rotate
welding table.
Rotate the welding table to its
upright position.