Miller 1025 Посібник оператора - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1025. Miller 1025 13 сторінок. Fluid head

Operating Instructions

2. Camera Set-up

2.1 Remove the CAMERA PLATE by pulling down the

SAFETY TAB while rotating the QUICK RELEASE KNOB

to the left. The CAMERA PLATE should pop out.

2.2 Refer to the Camera's owners manual for correct method

of attachment to the CAMERA PLATE.

2.3 Attach

camera

accessories,

RELEASE TRIPOD ADAPTER (if required) to the camera, it is

recommended to estimate the camera's Centre of Gravity (C

of G) for the purpose of correctly positioning the camera on

the CAMERA PLATE. The camera's C of G can be estimated

by placing the camera on to a round rod and then shifting

it backwards or forwards until a balance point – C of G - is

achieved. It is recommended to identify this point on the

camera as it will be useful in step 2.5.

2.4 Attach the CAMERA PLATE to the QUICK RELEASE TRIPOD

ADAPTOR such that the C of G mark on the camera is

approximately 10 – 20 mm behind the front edge of the

CAMERA PLATE then securely tighten the screws.

2.5 Align the CAMERA PLATE with the SLIDING PLATFORM

(ﬁg. 1) and slide it in until the safety mechanism is

engaged.

battery

and

the

QUICK

2.6 Release the SLIDING PLATFORM LOCK and slide the

SLIDING PLATFORM such that the camera's C of G is

directly above the centre axis of the Fluid Head (ﬁg. 6) and

tighten the SLIDING PLATFORM LOCK (ﬁg. 6). If this can

not be achieved then reposition the CAMERA PLATE on

the QUICK RELEASE TRIPOD ADAPTOR – step 2.4. This

will ensure that the system has maximum stability.

C of G

Fig. 6

Sliding

platform

Sliding

platform

lock