Miller 1036 Посібник оператора - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1036. Miller 1036 13 сторінок. Fluid head

Operating Instructions

2. Camera Set-up

2.1 Remove the CAMERA PLATE by pulling down the SAFETY

TAB while rotating the QUICK RELEASE KNOB to the left.

The CAMERA PLATE should pop out.

2.2 Refer to the Camera's owners manual for correct method of

attachment to the CAMERA PLATE. Inspect the CAMERA

PLATE and remove the 1/4" and 3/8" screws (for HDV

mount) or the 1/4" + PIN CARRIAGE (XDCAM/P2HD mount)

as required. The 1/4"and 3/8" screws can be stored

underneath the SLIDING PLATFORM (fig. 1).

2.3 Attach camera accessories and the battery to the camera,

it is recommended to estimate the camera's Centre of

Gravity (C of G) for the purpose of correctly positioning

the camera on the CAMERA PLATE. The camera's C of G

can be estimated by placing the camera on to a round rod

and then shifting it backwards or forwards until a balance

point – C of G - is achieved. It is recommended to identify

this point on the camera as it will be useful in step 2.5.

2.4 Attach the CAMERA PLATE to the camera or the QUICK

RELEASE TRIPOD ADAPTOR and securely tighten the

screws.

2.5 Align the CAMERA PLATE with the SLIDING PLATFORM

and slide it in until the safety mechanism is engaged.

2.6 Release the SLIDING PLATFORM LOCK and slide the

SLIDING PLATFORM such that the camera's C of G is

directly above the centre axis of the Fluid Head and tighten

the SLIDING PLATFORM LOCK (fig.5). If this can not be

achieved then reposition the CAMERA PLATE on the

Camera or the QUICK RELEASE TRIPOD ADAPTOR – step

2.4. This will ensure that the system has maximum stability.

C of G

Fig. 5

Sliding

platform

Sliding

platform

lock