Miller 1050 Посібник оператора - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1050. Miller 1050 13 сторінок. Fluid head
Також для Miller 1050: Посібник оператора (13 сторінок)

Друкувати сторінку

Maintenance

The Skyline 70 Fluid Head offers high quality surface coatings.

Miller recommends keeping the Fluid Head clean at all times by

using soft brushes and lint free cloth to wipe over the surfaces.

• Do not immerse the Fluid Head in any liquid.

• Do not use stiff brushes, abrasives, harsh detergents and

solvents.

Battery Replacement

The Skyline 70 Fluid Head uses a single GP23A type - 12 Volt

battery for Illumination. Miller recommends the following batteries

to provide long life performance – GP23A, Duracell MN21/23 or

Vinnic L1028.

1 Using a Phillips Head #1 screw driver, remove the RETAINING

SCREWS and the BATTERY DOOR.

2 Using a small flat screw driver remove the battery.

3 Align the new battery as shown on the back of the BATTERY

DOOR and place into the BATTERY HOUSING, then push down

the battery into place. A small flat screw driver may be used to

push down the battery into the BATTERY HOUSING.

4 Align the BATTERY DOOR into the body then tighten the

screws lightly.

Battery

Illumination Button

Battery Housing

Battery Cover

Retaining Screws

Fig. 8