Miller 1050 Посібник оператора - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник оператора для Аксесуари для фотоапаратів Miller 1050. Miller 1050 13 сторінок. Fluid head
Також для Miller 1050: Посібник оператора (13 сторінок)

Друкувати сторінку

Operating Instructions

The operating instructions are described in six steps. Please

read and understand these instructions before using this

equipment. Do not omit any steps.

1 Fluid Head Set-up

1.1 Loosen the PAN HANDLE CLAMP fully then rotate the

PAN HANDLE until it is approximately perpendicular to the

THREADED STUD (fig. 4) and tighten the PAN HANDLE

CLAMP - avoid contact wear between the serrations

on the Fluid Head and the PAN HANDLE CLAMP , if this

occurs then unwind the PAN HANDLE CLAMP further.

1.2 Ensure that the TRIPOD BOWL is approximately

horizontal. Place the Fluid Head into the TRIPOD BOWL,

adjust the BUBBLE LEVEL (fig. 4) such that the bubble is

inside the black circle and tighten the CLAMP NUT.

1.3 Set the initial control settings as follows – see Figure 1 & 2:

 Select Counterbalance to position 8 (top setting).

 Select Pan & Tilt Drag to position 0.

 Tighten the PAN LOCK, TILT LOCK and the SLIDING

PLATFORM LOCK.

Pan Handle Clamp

Pan Handle

Illumination Button

Bubble Level

Threaded Stud

Clamp Nut

Fig. 4