Diamir Scout 11 Інструкція з експлуатації Посібник з експлуатації - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Засоби безпеки Diamir Scout 11. Diamir Scout 11 11 сторінок. Safety alubar system
Друкувати сторінку
Operating instructions Safety Alubar System
• If you have purchased this binding on the internet, a specialist dealer must mount and adjust the binding. If any mountings and settings have
been made by an unauthorised person, we will not be liable.
• Check your binding each time before use. If any parts are damaged or missing, it should not be used.
• Any alterations to the binding, improper mounting and adjustment or use with incompatible accessories, increase the risk of non-release or defec-
tive release.
• The bindings must be mounted directly on the ski (without extraneous components), especially so that the functioning of the ski brakes is not
impaired.
• Only use the binding with a corresponding ski brake. Failure to observe this can result in the ski sliding down without breaking after release,
endangering people's life and health.
• The braking action of the ski brake is not sufficient in the deep snow.
• Worn or damaged boots can have a negative influence on the release. Get your equipment annually check by a specialist dealer.
• Settings higher than DIN value 10 are not subject to DIN ISO standards. Settings in this numbers are at your own risk.
Care, storage, warranty
The warranty provided by Fritschi AG Swiss Bindings is given on condition that these operating instructions are observed.
The binding must be checked and if necessary readjusted before each new season by a specialist dealer.
Any repairs must be carried out by a specialist dealer or by the manufacturer.
Care
Remove all kind of material. If the binding is dirty, clean it with a damp cloth or rinse it carefully. If too much water or pressure is used the grease
may be rinsed out.
Storage
When storing the binding close the heel unit.
When transported protect the binding from dirt and salt.
After alpine touring and / or skiing, store the skis in a dry and warm room. This prevents the binding mechanism from icing or corrosion.
Warranty
An executed warranty certificate provides consumers with a warranty for 24 months from the date of purchase for any defects that can be shown
to be attributable to manufacturing errors or faulty material. The warranty does not apply to rental bindings. The warranty is only valid if work done
on the bindings such as mounting, adjusting, adaptation and repairs has been performed by a specialist dealer.
Damage that arises through natural abrasion, excessive or improper use, external influences such as fire, heat, water, etc., through non observance
of the instructions, improper care, no or non conform maintenance, are not considered as defects and are, thus, excluded from all warranties.
EN
5