Miller CS310A Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Ліхтарик. Miller CS310A. Miller CS310A 20 сторінок.
Друкувати сторінку
4-7. Connecting Torch
A. Connecting Water-Cooled Torch When Using A Freestanding Coolant System
11
10
5
Tools Needed:
5/8, 7/8, 1-1/8 in.
!
Turn Off welding power source and
cooling system power before in-
stalling torch.
.
If applicable, install high-frequency
unit.
1
Welding Power Source
2
Regulator/Flowmeter
3
Gas Cylinder
4
Gas Hose (Customer Supplied)
OM-251981 Page 8
1
7
12
Obtain correct length with 5/8-18 right-hand
fittings.
5
Torch
6
Power Cable Adapter
7
Coolant Hose (Customer Supplied)
Obtain correct length with 5/8-18 left-hand
fittings.
8
Coolant-Out Of Torch/Power Cable
(Red)
2
6
8
9
Connect coolant-out of torch/power cable
to power cable adapter, and connect adapt-
er to weld output terminal.
9
Torch Gas Hose
10 Coolant-Into Torch Hose (Blue)
11 Cooling System
12 Work Clamp
Connect work clamp to a clean, paint-free
location on workpiece, close to the weld.
Use wire brush or sandpaper to clean weld
joint area.
3
4
802560