Miller ICE-40C Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Ліхтарик. Miller ICE-40C. Miller ICE-40C 40 сторінок. Air-cooled torches for plasma arc cutting
Також для Miller ICE-40C: Посібник користувача (40 сторінок), Посібник користувача (38 сторінок)
Друкувати сторінку
4-6. Connecting Work Clamp and Gas/Air Supply
2
5
4
From Gas/Air Supply
OM-2239 Page 12
1
3
Rear of Unit
1
2
Connect work clamp to a clean,
paint-free location on workpiece, as
close to cutting area as possible.
.
3
4
.
5
Obtain hose with 1/4 NPT right-
hand thread fitting. Wrap threads
with teflon tape (optional) or apply
pipe sealant, and install fitting in
opening. Route hose to gas/air
supply.
Or
Install supplied quick connect male
1/4 in NPT pipe fitting.
Connect female quick connect
fitting to pipe fitting.
Tools Needed:
Route hose to gas/air supply.
5/8, 1-1/8 in
Y Incorrect plasma gas can
Work Clamp
Workpiece
Use only clean, dry air with 90
to 150 psi (620 to 1035 kPa)
pressure. Prevent moisture
from entering air supply at
extreme cold temperatures.
Gas/Air Inlet Opening
Hose
Hose must have a minimum
inside diameter of 3/8 in
(9.5 mm).
Teflon Tape
cause torch
and power
source damage. Use only air
or nitrogen for the plasma
gas.
Ref. 803 640-A / 803 221