Miller ICE-40C Посібник користувача - Сторінка 24
Переглянути онлайн або завантажити pdf Посібник користувача для Ліхтарик. Miller ICE-40C. Miller ICE-40C 40 сторінок. Air-cooled torches for plasma arc cutting
Також для Miller ICE-40C: Посібник користувача (40 сторінок), Посібник користувача (38 сторінок)
Друкувати сторінку
5-6. Sequence Of Gouging Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
455
Hold torch at approximately
°
45
angle to workpiece.
OM-2239 Page 20
.
Set air pressure to 55 PSI (379 kPa) for gouging.
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press trigger. Pilot
arc starts. Move tip to within approxi-
mately 3/16 in (4.8 mm). Start gouging
across workpiece surface. Maintain
°
approximately a 45
angle to surface.
Release trigger. Postflow continues for
approx. 20 seconds after releasing trigger;
arc can be instantly restarted during postflow
by raising trigger lock and pressing trigger.
Ref. 803 640-A / 801 400-B