Aquaox C Series Посібник із швидкого старту - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Блок управління Aquaox C Series. Aquaox C Series 8 сторінок. Clack head

If you do want to irrigate with soft water we recommend the use of potassium chloride salt

(widely available) instead of regular sodium chloride (water softener rock salt). Any type of salt

though can be used in the water softener.

Fig 2 Clack WS1 Softener Control

Adding Softener Media & Installation Instructions

1. Unscrew by hand the Clack WS1 control valve from top of the tanks if it was shipped screwed

on. Place distributor tubes in tank if not already inside tanks. If not already done, make sure

blue cap is on top of distributor tube, or wrap the top of distributor tube with electrical or duct

tape. The idea is you do not want gravel or resin to go down the distributor tube when you are

adding media.

2. Add filter gravel supplied first, using the funnel sent with the water softener.

3. Next add softener resin media. Tank will be approximately 2/3 to the 3/4 full.

4. Remove cap or tape from top of distributor tube. Be careful not to pull up distributor tube

when removing cap or tape.

Clack WS1 Water Softener Installation Guide