Chromalox 2110 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Регулятор температури Chromalox 2110. Chromalox 2110 20 сторінок.

Друкувати сторінку

Chromalox 2110 Інструкція з експлуатації

1. Quick Setup

After the controller is properly wired into the system,

the user only needs to verify the sensor input and con-

trol type and adjust the set point.

Setting the Sensor and Control Mode

Adjust the dip switches located on the bottom of the

unit as shown in Figure 1.1. The factory settings are J,

TC, °F, and PI. It is simpler to adjust the dip switch prior

to mounting the 2110.

RTD

˚C

˚F

ONOF

Figure 1.1

Dip Switch Settings

RTD

˚C

˚F

ONOF

Adjusting the Set Point

1. Apply power to the unit.

2. To adjust the set point on the Chromalox 2110 Tem-

perature Controller, press and hold the Set Point

button (see Figure 1.2). The Set Point light is illumi-

nated.

3. While still pressing the Set Point button, press either

the

button to adjust the set point to the de-

sired value (see Figure 1.3). Holding the

ton increases the speed of the set point changes.

Chromalox

2110

Load

°F

Alarm

°C

Temp

Set Point

Point

Figure 1.2

Establishing the Set Point

The Controller is now operational with factory settings.

For more precise control, set up of the alarm, etc., see

Section 4 – Adjusting Set Point and Configuration.

but-