Aquaphile Eazydive Air compressor Характеристики та інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Характеристики та інструкція з експлуатації для Водолазний інструмент Aquaphile Eazydive Air compressor. Aquaphile Eazydive Air compressor 2 сторінки.
Друкувати сторінкуThe ambient air should be as pure as possible. Absolutely avoid the proximity of an engine exhaust, smoke and suspicious
odors. Preferably inflate in the open air or in a ventilated place. If the intake air is of good quality, the air contained in
EAZYDIVE will be of good quality and will easily check the standard in this matter: European Standard EN 12021.
The compressor is not lubricated with oil, so there is NO trace of oil in the air breathed.
Instructions for inflation :
Do you know how to inflate your car tires? Then you know how to inflate EAZYDIVE!
Connect the compressor clamps to the battery terminals. If your battery is normally charged, you do not need to
start the engine. Electric consumption of an EAZYDIVE inflation: 2 Ah.
Connect the compressor hose onto the compressor (quick release "push-pull").
Connect the compressor hose onto the tire type valve at the top of the bottle.
Push on the handle and insert the pin (lower handle position: valve open).
Start the compressor (switch on).
Check the manometer (pressure gauge) during inflation.
At 12 bars, stop it. Beware not to leave it in operation once this pressure is reached.
Remove the pin (handle in the upper position: valve closed)
Remove the hose from the valve. It is normal that there is a slight leak before the valve shell is completely closed.
The inflation time (about 5 mn) is indicative, they depend on the battery charge.
If you go diving directly, don't forget to put the pin again (valve open) for the air supply of the regulator.
Follow the EAZYDIVE instructions.
How many times can EAZYDIVE be inflated with the compressor on a boat's batteries without starting the engine ?
The compressor will consume an average of 25 Amperes during 5 minutes ie about 2 Ah.
Most medium-sized boat batteries have a capacity of 60 to 110 Ah.
You could perform a tenth or so re-inflations without worries, while keeping more than two third potential of the battery,
but everything depends on the other consumptions on board and the state of your battery.
Caution: The primary role of the battery is to start the engine and power the on-board circuits.
If you have two 12 V batteries in parallel, common case on boats, it would be good to:
Isolate one of them,
Make the EAZYDIVE refills on one of the two, the second remaining in reserve,
Reconnect both batteries after recharging.
Air supply for hookah diving:
The use is the same as for tank inflation, but clamp the hookah hose to the compressor inflation hose. Please refer to the
hookah's instructions for use.
The battery consumption for a 60 mn dive is about 25 Ah.
Maintenance :
The compressors require no maintenance. Store them in their bag, avoid shocks and sea water, in this case clean it with a
damp sponge, never with a lot of water.
Once a year, check the air filter. If necessary, flush the hose to clean it or change it.
Precaution of use :
After several consecutive refills or in hookah use, the metal parts of the compressor can be very hot.
with bare hands an wait until it cool
down. Grasp the compressor only by its handle.
Don't touch them