BURL B2 Bomber DAC Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Музичне обладнання BURL B2 Bomber DAC. BURL B2 Bomber DAC 17 сторінок. B2 bomber adc b2 bomber dac with dante

Друкувати сторінку

There are 3 ways to clock the B2 Bomber ADC/DAC with Dante:

1. B2 ADC/DAC set to Internal. Brooklyn II (BKII) card set to External (Recommended)

2. B2 ADC/DAC set to External Clock, BKII card set to External

3. B2 ADC/DAC set to Dante, BKII card set to Internal

SEE FIGURE 12 (NEXT PAGE) FOR B2 INTERNAL CLOCKING DIAGRAM

CLOCKING B2 BOMBER ADC/DAC TO INTERNAL WORD CLOCK:

1. Set B2 front panel to INT

2. Open Dante Controller, select DEVICE INFO

3. Double Click on device "B2-xxxxxx"

4. Click on CLOCK STATUS. (Fig. 11, below)

5. Set B2 Bomber to "Preferred Master", and "Enable to sync to External

6. Make sure each device including host DAW is set to correct sample rate in

Fig. 11: Example shows B2 ADC on Internal clock. Dante card is synced to B2 clock. (Recommended)

NOTE: PREFERRED MASTER REFERS TO DANTE NETWORK, NOT B2 FRONT PANEL!

DANTE CLOCKING

Device Config (as per step 8, page 9)