chromatec ALARMS-xx Series Посібник з налаштування - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з налаштування для Система безпеки chromatec ALARMS-xx Series. chromatec ALARMS-xx Series 9 сторінок. Remote alarm unit

Друкувати сторінку

Chromatec

Network Connection and Setup

Should the ALARMS-xx to be connected via LAN, the network settings of the ALARMS-xx are

configured entirely by the AM-xx / MADI-xx. Multiple ALARMS-xx configurations can be present on

the same network, therefore an AM-xx / MADI-xx does not automatically acquire alarm units that it

finds on the network; this has to be done manually from the AM-xx / MADI-xx menu. With the AM-xx

/ MADI-xx and ALARMS-xx connected to the network, the following steps must be carried out to start

controlling the ALARMS-xx:

1) Open the AM-xx / MADI-xx menu and go to the ALARMS → ALARMS-xx 1 menu.

2) Go to ADD NEW → NONE FOUND (If an ALARMS-xx has already been found then this

will be ADD NEW → ALARMS-xxs FOUND).

3) Press INSERT+LOCK on the SEARCH AGAIN item to initiate a search for all

ALARMS-xxs present.

4) If any ALARMS-xxs are found, then NONE FOUND will change to ALARMS-xxs FOUND

and the list of units will appear below.

Note:

If installing multiple new ALARMS-xxs, it's a good idea to connect them one at a time to the network, because

they will all have the same default IP address and will therefore not be distinguishable from one another.

5) Scroll down to the new ALARMS-xx found and press INSERT+LOCK to add it to the list

of acquired ALARMS-xxs.

6) Once acquired by the AM-xx / MADI-xx, the ALARMS-xx's IP address can be changed if

necessary, by going back to the ALARM → ALARMS-xx N → IP ADDRESS menu,

changing the IP address bytes and pressing INSERT+LOCK to send the new settings to

the ALARMS-xx.

Notes:

1) If required, the same alarm status information may be relayed to different areas via

multiple ALARMS-xx units by setting the DIP switches of cascaded units to the identical

channel groups.

2) All ALARMS-xx units in the same system must be connected either via RS422 or LAN

and not by a combination of the two methods.

ALARMS-xx

Version 1.0