CHROME UPS-HEATST-PSWL350W-CHR 10KS Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для ДБЖ CHROME UPS-HEATST-PSWL350W-CHR 10KS. CHROME UPS-HEATST-PSWL350W-CHR 10KS 11 сторінок. Uninterruptible power system
Друкувати сторінку
Step 3: online communication
Communication port: RS-232 interface
USB port
In order to turn off / turn on the UPS system or monitor the state thereof, a connecting wire can be used for connecting the
two terminals respectively to the UPS system and the USB/RS-232 interface of a computer. In this way, once you install
the corresponding monitoring software, you can turn off / turn on and monitor the UPS system through a computer.
Step 4: turn on UPS
Press <ON / MUTE> on the front panel for two seconds to turn on the UPS system;
Note: for initial use, the battery should be charged for five hours. If the UPS system is not charged for five hours, the
discharge time of the battery will be reduced.
Step 5: software installation
In order to provide the most perfect protection for the computer, you can install UPS monitoring software and finish
relevant UPS settings. You can insert the optical disk attached with the product into your optical disc driver and install the
monitoring software. If the optical disk is not attached in the package, please follow the step below to download the
monitoring software through Internet and install it:
1. Follow the instructions in the screen to start the software installation.
2. After the computer is restarted, the orange socket of the monitoring software will appear at the tool bar near to the clock.
Step 6: external battery (only applicable to the long run time model)
Please refer to the following figure for connecting the external battery.
+ Positive pole of battery
-Negative pole of battery
4