AquaPRO 03AP546 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Системи фільтрації води AquaPRO 03AP546. AquaPRO 03AP546 8 сторінок. Pressure filter uv clarifier
Також для AquaPRO 03AP546: Інструкція з експлуатації (16 сторінок)
Друкувати сторінку
IMPORTANT SAFEGUARDS
IMPORTANT: IF USED IN MARINE OR
SALTWATER, DUE TO THE HARSH
CONDITIONS THE WARRANTY IS VOID.
•
Do not submerge this filter in water.
•
Do not operate the filter without water at any time, permanent damage
may occur.
•
Do not look at an unshielded UV-C globe. Ultra Violet light is harmful to
your eyes and may cause blindness.
•
Do not over pressurise. Max head pressure is 3m.
•
The filter is designed to be used in pond environment. It is not to be used
in any other manner or purpose. The filter should only be used with water.
Do not use the filter with any harsh chemicals such as a solvent or petrol.
•
All pumps and filters are water cooled. If the flow becomes restricted it
could cause permanent damage. The filter needs to be cleaned regularly
to prevent the filter becoming blocked, thus causing damage. This is not a
warrantable event. For your own safety, disconnect from the power supply
before any maintenance of any equipment is attempted on the tank or
water body.
•
Do not operate the filter if any components of the system, such as the
power cable, have been damaged.
•
If required, hove a qualified electrician install a weather proof power point
near to the pond or water feature (within the coble length of the filter).
•
Always use a properly grounded power supply that is connected to an
RCD with a rated residual operating current not exceeding 30mA. As per
AS/NZS 3350.2.41:1997
•
The drip loop method should be used to prevent water from traveling down
the cable and onto the plug or power supply. If the plug does get wet, do
not unplug the cable. Disconnect the circuit breaker that supplies power
to the power supply point. Then unplug and examine the plug and power
supply point for presence of water. If the power point has become wet,
you should consult an electrician before using the power point again.
•
Always unplug the pump from the power supply when not in use or before
performing any maintenance on the pump or on the aquarium. Never pull
the power cord to disconnect the plug from the power supply. Grasp the
plug and pull to disconnect. Care should be taken to arrange the power
cable so that it cannot be accidentally tripped over or pulled.
•
Do not install or store the appliance where it will be exposed to extreme
hot or cold temperatures. Do not use with water above 35 ° C.
•
Do not cut the cable as this will result in voiding your warranty. The
power cord cannot be replaced. If the cord is damaged, the filter must be
discarded.
•
Do not attempt to repair the electrical appliance yourself. Return to an
authorized service centre or place of purchase if a fault occurs, (regular
maintenance is not considered repair and is required by user).
FOR MORE INFORMATION AND THE
COMPLETE AQUAPRO RANGE
VISIT WWW.AQUAPROONLINE.COM.AU
HOTLINE
AQUAPRO AP5000UV Instructions.indd 8
AQUAPRO AP5000UV Instructions.indd 8
1300 278 283
EMAIL
WWW.AQUAPROONLINE.COM.AU
WARRANTY
WARRANTY COVERS ONLY APPLIANCE
DEFECTS, FAULTY MATERIAL AND
WORKMANSHIP WITHIN A 2 YEAR PERIOD.
•
This product comes with a warranty against defects and motor failure
(Warranty). The benefits provided in this Warranty are in addition
to other rights and remedies available to you under the Australia
Consumer Law. The Warranty is provided to the original purchaser of
the product on the following terms:
•
The Warranty is given by Aquatec Equipment Pty Ltd trading as
Aquatec Equipment: 37 Edison Cct, Forrestdale, WA 6112. Tel 1300
552 202 or email [email protected].
•
To make a claim under the Warranty you must return the faulty
product to the place of purchase with a valid receipt or proof of
purchase.
•
A Warranty claim must be made within 2 year of the date of purchase.
•
If your claim complies with the above terms and the product is not an
Exhaustible Item and no Voiding Events have occurred, we will (at our
sole discretion):
- repair the product, if possible; or
- provide a replacement product; or
- if a replacement product is not available, provide a refund for
the purchase price paid.
•
You will bear the cost associated with claiming under the Warranty
such as the cost of transportation and delivery of the product to and
from the place of purchase.
•
The product contains a complete Impellor Set, O Ring, UV Globe &
Sponge Filters. These items are exhaustible (wear & tear) and are not
covered under the Warranty.
•
The Warranty will be void if any of the following events occur, as
determined by us, at our sole discretion (Voiding Events):
- any tampering/removal of warranty/identification labels or
electrical components is evident;
the defect has arisen due to: an accident, incorrect or inadequate
installation, misuse or abuse
of the product (including improper maintenance and service),
excessive wear and tear, not
following manufacturer's guidelines/ instructions, or the product
has been used in a manner
contrary to the purpose or suitability of the product;
- the product has been modified without our authority;
- the defect is caused by power surges/spikes brownouts.
•
Loss of livestock, damage to property or personal injury caused by
the improper use or abuse of the product will not be covered and
the manufacturer excludes all liability for such events, to the extent
permitted by law.
•
In addition to the Warranty set out above, our goods come with
guarantees that cannot be excluded under the Australian Consumer
Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced
if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
+61 (8) 6260 1000
PHONE
-
13/5/2022 8:23 am
13/5/2022 8:23 am