Burley Tandem Supplement Посібник - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник для Велосипед Burley Tandem Supplement. Burley Tandem Supplement 12 сторінок. Suppliers association multi-speed bike manual

Друкувати сторінку

Before Each Ride

•
Check tire pressure. Fill to the maximum pressure on the sidewall, using an
accurate gauge. Caution: do not overinfl ate.
•
Check and tighten all mounting screws and hardware.
•
Make sure gears are properly adjusted.
•
Clean and lubricate chains periodically.
•
Check brakes, and adjust if necessary.
•
Verify that the timing chain is properly tensioned.
•
Check headset adjustment.
•
Secure your tool kit and pump in place.
•
Verify that the tires and wheels are in good condition.
•
Make sure the quick-release levers for the wheels are secure and prop er ly
positioned. See section IIA of this manual for in for ma tion on quick-release levers.
See your Burley dealer for a hands-on dem on stra tion if you aren't absolutely sure
how to operate your quick-release levers.
Mid-Season Maintenance
This should be done every 1,000 miles or 4–6 months. If you are riding high mileage
(over 100 miles per week) or in rain or off-road, you will need to perform this
maintenance every 2–3 months. In addition to your "Before Each Ride" inspection:
•
Inspect all brake and derailleur cables for fraying and replace as necessary.
•
Check and tighten fi xing bolts for crank arms to 18–20 ft.-lb. Also check and
tighten chainring bolts.
•
Inspect pedals, toe clips, and straps for cracks or loose parts.
•
Verify that seats are properly positioned and securely tightened.
•
Check and adjust hub brake (if applicable).
•
Check and tighten all nuts and screws on your bike.
•
Clean and lubricate pivot points on shifters, derailleurs, brakes and levers; wipe
excess oil to prevent dirt buildup, and keep oil clear of brake and rim surfaces.
•
Inspect and replace any worn brake pads.
•
Carefully inspect tires for cracks; if in doubt, replace your tires.
•
Check wheels for trueness; inspect for cracks at the spoke hole or sidewall. Retrue
or replace as necessary.
•
Remove seatposts from seat tubes and apply a thin fi lm of light weight grease on
your seat posts to prevent corrosion and to make adjustment easier.
•
Clean and wax your bike's fi nish. Good products for cleaning powder coat fi nishes
include:
•
Simple Green
•
Mild soap and water
•
Vinegar and water
•
A good quality car wax generally works well, but remove
excess wax within fi ve minutes after applying.
11
Burley Tandem Suppplement