Mounting the Reflectors
Cub
: Factory-installed
Bee
™
All other models:
FRONT: Clear front reflectors are mounted horizontally to both sides of the
trailer fabric front. "TOP" is marked on the reflector front. Locate the grom-
mets on the trailer fabric front, insert the screw into the reflector back through
the grommet, and tighten snugly. Repeat for the other side.
REAR: Red reflectors are mounted horizontally to both sides of the rear of the
main frame tube, with the reflectors extending out past the sides.
1. Snap the posts on the red reflectors into the openings in the reflector
brackets, and with the provided screw, screw the pieces together.
2. Loosen the black screw next to the clamp (A) on the reflector bracket.
Slide the bracket clamp onto the rear side section (B) of the main
frame tube. Make sure the reflector side marked TOP is to the top.
3. Tighten screw snugly, making sure reflector extends out past the trailer
side. Repeat for the other side.
A
B
C
Make sure both reflectors face outward. Incorrectly installed reflectors
can reduce visibility at night and cause an accident or serious injury.
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
: Rear Reflectors Only
™
Mounts
horizontally
to frame
WARNING
Attaching the Wheels
First, verify that the tires are inflated to 30-35 P.S.I. Tip the trailer frame
onto its rear end. With the quick-release lever in the "OPEN" position, insert
the wheel axle assembly completely into the hollow trailer axle, making sure
that the horizontal shaft goes all the way into the axle. Tighten the thumb
nut, so that you feel resistance halfway though tightening the lever. Once the
wheel is fully seated in the hollow axle, position the quick-release lever so
that it is aimed to the rear of the trailer in the "CLOSED" position (the lever
is marked for OPEN or CLOSED positions). Repeat for the other wheel. Note:
wheels are not centered on the axle.
Quick-release
lever in unlocked
"Open" position
WARNING
Make sure wheels are held securely, with wheel shaft fully inserted into
the hollow axle. You should not be able to rock or shift wheels. Improp-
erly installed wheels can fall off, causing an accident or serious injury.
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Quick-release
lever in locked
"Closed" position
Друкувати сторінку