Burlington T51 CHR Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Сантехнічний виріб Burlington T51 CHR. Burlington T51 CHR 2 сторінки. Basin stand

Друкувати сторінку

Basin Stand

- T21A CHR/T22A CHR/T23A CHR/T24A CHR/

T49A CHR/T50 CHR/T51 CHR/T52 CHR

Installation Instructions

Introduction

All parts have been fully inspected throughout the production process

and only leaves our factory after a 15 stage QC process.

Carefully remove the items from the box and check that all parts have

been supplied.

Installation should be completed by at least two suitably competent

installers

Before beginning installation, please check for any damage that may

have occurred during transport.

Improper installation shall result in loss of warranty in case of damage

caused by impacts or rubbing against rough surfaces.

You may need to source alternatives depending on the material and

IMPORTANT: Please read these instructions carefully before you

begin and retain for future reference.

We do not accept responsibility for any problems that may occur

through incorrect installation.

Installation notes

NOTES: The installation must comply with all plumbing codes including

local codes and be installed by a licensed plumbing contractor.

Assemble the parts on a mat to protect against scratching the surface.

Avoid getting cement, grit, sand or masonry products on to the surface.

Protect and cover the items during installation, other tradesmen

might damage them if no precautions are taken.

connecting to any existing pipe work or doing any maintenance.

WARNING! Please check for any hidden pipes and cables, electric

Tools required

Tape

Safety

measure

glasses

drill

Parts supplied - basin stand

Floor nipple washers

Rubber washers

Basin Stand Extension Kit

Hammer

Flat head

Pencil

screwdriver

Installation - basin stand

Please make sure you have the correct basin suitable for the basin legs. The recommended combination is as follows: T21A CHR with B8,

T22A CHR with B1/B2/B4, T23A CHR with B3/B5, T24A CHR with B6, T49 CHR with B14/B15/G1, T50 CHR with B18, T51 CHR with

B19,T52 CHR with B20.

Attach the two horizontal rails to the front rail.

Screw the legs into the rail.

NOTE: at this stage, if you are using the regal designer basin stand

Floor nipples

Extension kit (T62), then refer to step 5 and then proceed to step 6.

Allen Key

Spirit

level

Attach both feet to the legs.

If the regal designer basin stand extension kit is being

installed, please refer to the illustration shown below. The kit