Aquasana EQ-300 Посібник користувача - Сторінка 8

Переглянути онлайн або завантажити pdf Посібник користувача для Системи фільтрації води Aquasana EQ-300. Aquasana EQ-300 16 сторінок. Whole house water filter
Також для Aquasana EQ-300: Посібник з монтажу (5 сторінок), Посібник користувача (16 сторінок)

Друкувати сторінку

INSTALLATION STEPS

Install Shut-off Valve and Ensure Spacing

NOTE: DO NOT cut more pipe than necessary. You can cut more pipe later if

needed. If you're also installing a Pro-Install Kit or bypass loop, do so at this time.

Incoming

water supply

Cut Pipes

Cut pipe along the marked sections from step

5 and clean ends of pipe. Ensure there are no

burrs, sharp edges or deep scratches.

NOTE: Cut tubing as straight as possible

with a utility knife, or an appropriate

pipe cutter for copper tubing or PVC.

Configure System

Fit Rhino tank and additional optional

add-ons into the system at this time.

Screw Pre-Filter support bracket onto

the wall and attach Pre-Filter.

Properly connect system together

accordingly (slip fittings, barbed fittings,

NSF certified PVC glue, etc.). Ensure all

parts are flowing through the "IN" port in

the correct direction of water flow.

Final System Check

Once installation is complete, allow proper time for glue to dry according to

manufacturer instructions. Then, slowly turn water on and inspect for leaks.

After inspecting for leaks, turn on the faucet closest to the installed unit

and allow water to run for 5-10 minutes for the final flushing period.

Ensure proper spacing to fit Pre-Filter, Rhino tank,

and any optional add-ons

(Cont. from previous page)

Outgoing

water supply