Panasonic AGDVC200 - DV CAMCORDER Інструкція з експлуатації Посібник з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Відеокамера. Panasonic AGDVC200 - DV CAMCORDER. Panasonic AGDVC200 - DV CAMCORDER 44 сторінки. Digital video camera recorder
Також для Panasonic AGDVC200 - DV CAMCORDER: Інструкція з експлуатації Посібник з експлуатації (45 сторінок), Технічні характеристики (4 сторінок)

Preparation

Recharge the battery pack using the battery charger specifically designed for each individual battery pack. For the charging time and other

details, refer to the operating instructions of the battery charger used.

Remove the battery holder.

Disconnect these.

Attach the battery case to the unit.

1Connect the unit's cable with the cable of the AU-M402H

battery case.

2Use a screwdriver to attach the AU-M402H battery case to

the unit.

The holes for tightening the screws can be seen when the

cover is opened and the rubber caps are raised. Use a

screwdriver to tighten the screws, and attach the battery

case to the unit. Ensure that the screws are tightened up as

far as they will go.

<Note>

≥Do not pull the rubber caps with great force.

≥Be careful not to catch up the cables when attaching the

battery case.

Screws

Connect here.

Battery holder

Rubber caps

AU-M402H

battery case

Connect the plug of the battery pack to the

connector inside the battery case, and

insert the battery pack into the case.

Label

surface

<Note>

Ensure that the power is turned off before connecting or

disconnecting the plugs.

Set the battery type.

Select the battery type using <BATTERY> on the sub-menu

screen.

Select "TYPE A" if the AJ-BP490 is to be used; select "NiCd12"

if the AU-BP402 is to be used. (See page 34)

AU-BP402

battery pack