AquaScape AquaForce 8000 Інструкція та обслуговування - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція та обслуговування для Водяний насос AquaScape AquaForce 8000. AquaScape AquaForce 8000 16 сторінок. Adjustable flow solids-handling pond pump
Друкувати сторінку
• The extremely versatile rotational ball outlet provides you
with the ability to adjust the pump discharge to the perfect
position required by your water feature. Loosening the
threaded collar allows you to rotate the upper half of the
ball (Ex. 5). A flat rubber washer seal is included to ensure
a leak-free connection. Make sure the flat rubber washer is
in place before installing the fittings (Ex. 6).
Ex.5
• Install the right sized multi-hose adapter based on the
diameter of the tubing you are using.
• If using a pipe diameter larger than the smallest section
of the multi-hose adapter, trim off the smaller sections to
avoid flow restriction (Ex. 7).
Hosetail ready for 1" tubing
Hosetail ready for 1½" tubing
CUT
HERE
• In some instances the tubing may be tight and difficult to
connect to the fitting. If this is the case, we recommend
heating the hose with a hair dryer or dipping the hose
in very hot water. Lubrication can also be used; we
recommend silicone grease or olive oil. Put the fitting on
the filter before attaching the tubing/hose. Once the fitting
is in place, attach the tubing/hose onto the fitting with a
twisting motion.
• Attach tubing to the fitting. If
tubing is loose on fitting, use
a hose clamp (not included)
to secure tubing into the
fitting (Ex. 8).
• Connect the other end of
the pump tubing to the pond
filter, such as a biological
filter, waterfall spillway, or
pressurized filter.
☎
aquascapeinc.com |
CAN (866) 766-3426 |
Ex. 6
Hosetail ready for 1¼" tubing
CUT
HERE
Installation of stainless
STAINLESS
steel hose clamp
STEEL HOSE
CLAMP
KINK-FREE
TUBING
Ex. 7
Ex. 8
☎
US (866) 877-6637
Smart Control Receiver Setup
• Mount the receiver above the ground on a post, fence, or
wall.
• Connect the pump to the Smart Control Receiver.
• Plug the Smart Control
Receiver into an outdoor-
rated GFCI, and the unit will
automatically enter pairing
mode (Ex. 9).
NOTE: The blinking blue
light on the face of the unit
indicates the receiver is in
pairing mode and ready to
be connected.
• Download the Aquascape Smart Control App (available on
iOS or Android App Store).
• Open the Aquascape Smart Control App and click 'Create
New Account' (Ex. 10).
NOTE: If you already have an account, login with your
username and password.
• Once logged in, click the three dashes in the upper right-
hand corner of the home screen (Ex. 11).
• Click 'Add New Device' (Ex. 12).
• Enter the WiFi network and password for the network to
which the unit will connect (Ex. 13).
Ex. 10
Ex. 11
NOTE: Adequate WiFi coverage is required (2.4g networks
supported).
• Continue to follow on-screen instructions to complete the
pairing process.
• To reset the device to
factory defaults, first turn
the unit off by pressing the
power button, then press
and hold the + and - buttons
for four seconds and release
when the LED display lights
up completely (Ex. 14).
Ex. 9
Ex. 12
Ex. 13
Ex. 14
5