AquaScape Ultra 2000 Інструкція та обслуговування - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція та обслуговування для Водяний насос AquaScape Ultra 2000. AquaScape Ultra 2000 16 сторінок. Fountain and statuary pump
Також для AquaScape Ultra 2000: Інструкції та обслуговування (16 сторінок), Інструкція з монтажу та обслуговування (7 сторінок)
NOTE: Always disconnect power before performing
maintenance or removing the front cage. Do not operate
with screens or sponge removed as it will void the
warranty.
• The filter sponge protects the pump from fine particles
such as sand which can damage the interior of the pump.
Remove and clean the filter sponge as needed by rinsing
with clean water.
• The inner filter screen should also be cleaned as needed.
Remove the inner screen by twisting it counterclockwise
(Ex. 13).
• Internal Pump Cleaning – If you have thoroughly cleaned
the filter screens and sponge and still have diminished
flow rates, you may need to clean the interior of the
pump. Remove the water chamber cover by rotating
it counter-clockwise ¼ turn and pulling outward (Ex.
14). This will expose the impeller assembly for closer
inspection. Carefully remove the impeller from the pump,
pulling outward until the impeller releases from the body
of the pump (Ex. 15). Be careful not to lose the two plastic
bearing washers on either end of the impeller or the
centering bushings that center the ceramic impeller shaft
on both ends.
• If your rotor assembly impeller and internal pump body
have excessive scale build-up, clean with a mild acid,
such as white vinegar or non-abrasive calcium, lime and
rust remover product. Use a sponge or soft-bristled brush
that won't scratch or damage the impeller or pump body
(Ex. 16). Removing scale build-up will allow your pump to
run like new again.
6
Ex. 14
REPLACING THE IMPELLER
• The impeller assembly is the only moving part on the
Ultra Water Pump and will experience wear and tear. If
you've cleaned the pump, as described above, and still
experience poor pump performance, it is most likely time
to replace the impeller. Replacing the impeller is extremely
easy. Replacement impeller kits are available through your
local Aquascape dealer.
• Note the orientation of parts in the photo below (Ex. 17).
The replacement impeller kits include all parts shown.
Make sure to remove all of the original parts from the
Ex. 13
inside of the pump before installing the replacement
impeller kit.
Centering Bushing
Bearing Washer
• A centering bushing is required on both ends of the
impeller shaft; one bushing is located inside the pump and
an outer bushing sits in the water chamber cover (Ex. 18).
• Slide the first interior bearing washer onto the ceramic
shaft (Ex. 19).
Ex. 15
• Place the ceramic impeller shaft into the pump, checking
to be sure the centering bushing seats inside the pump
(Ex. 20).
• Carefully slide the impeller back onto the shaft (Ex. 21).
Use caution: the impeller assembly is magnetic and will be
pulled forcefully back into the pump.
☎
US (866) 877-6637 |
Ceramic Shaft
Ex. 18
☎
CAN (866) 766-3426 | aquascapeinc.com
Ex. 16
Impeller
Ex. 17
Ex. 19