Diamond 65/40 PCE Встановлення - Використання - Обслуговування - Сторінка 16
Переглянути онлайн або завантажити pdf Встановлення - Використання - Обслуговування для Діапазони Diamond 65/40 PCE. Diamond 65/40 PCE 19 сторінок. Range, gas solid top
Також для Diamond 65/40 PCE: Встановлення та обслуговування (19 сторінок)
Друкувати сторінку
ELECTRIC COOK TOP/ELECTRIC STOCKPOT STOVE
THE HOTPLATE DOES NOT HEAT.
Possible causes:
-
Hotplate defective.
ELECTRIC OVEN
THE APPLIANCE DOES NOT HEAT.
Possible causes:
-
Temperature thermostat defective.
-
Heating elements defective.
-
Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
-
Temperature thermostat defective.
25. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE
CARRYING OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS HOB
REPLACING THE GAS TAP.
-
Remove the control panel.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
GAS SOLID TOP RANGES
REPLACING THE GAS TAP AND PIEZO IGNITER.
-
Remove the control panel.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MAIN BURNER, PILOT BURNER,
THERMOCOUPLE AND IGNITER.
-
Remove the hotplate.
-
Remove the control panel and internal guards.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
GAS OVEN
THERMOSTATIC TAP AND PIEZOELECTRIC UNIT
REPLACEMENT
-
Remove the control panel.
-
Remove the bulb from its seat on the side of the
oven.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER
-
Open the oven door.
-
Remove the floor and the plate positioned on top
of the burner.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE THERMOCOUPLE
-
Remove the control panel.
-
Open the oven door.
-
Remove the floor and the plate positioned on top
of the burner.
-
Remove and replace the component.
-
Reassemble all parts. For assembly, proceed in
reverse order.
GAS STOCKPOT STOVE
18