AquaScape SMART CONTROL RECEIVER Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Приймач AquaScape SMART CONTROL RECEIVER. AquaScape SMART CONTROL RECEIVER 2 сторінки.

Друкувати сторінку

I N S T A L L A T I O N

SMART CONTROL

RECEIVER

Smart Control Receiver

Item #45038

Contents - #45038

No.

Description

Smart Control Receiver

Smart Control Conversion Plug

REQUIRED

• Adequate Wi-Fi coverage reaching to the unit (2.4 GHz networks supported)

• Aquascape Smart Control App (available on iOS or Android App Store)

Safety Information

WARNING: It is recommended whenever working in or near

water to have all electrical devices plugged into a ground fault

interrupter (GFCI) that has been installed by a licensed electrician.

• The power cable should be protected at all times to avoid punctures,

cuts, bruises, and abrasion.

IMPORTANT: Aquascape, Inc. is not responsible for losses, injury,

or death resulting from a failure to observe these safety precautions,

misuse or abuse of pumps or equipment.

Installation

• Mount the receiver above the ground on a post, fence, or wall (Ex. 1).

• Connect the pump to the Smart Control Receiver.

NOTE: If connecting a previous generation of the Adjustable Flow Pump,

please use the included Conversion Plug (Ex. 2).

• Plug the Smart Control Receiver into an outdoor rated GFCI, and the unit

will automatically enter pairing mode (Ex. 1).

Ex. 1

NOTE: The blinking blue light on the face of the unit indicates the receiver

is in pairing mode and ready to be connected.

facebook.com/AquascapeInc

youtube.com/aquascape4

twitter.com/AquascapeInc

45038 Smart Control Receiver [instructions].indd 1

Ex. 2

I N S T R U C T I O N S

• Download the Aquascape Smart Control App (available on iOS or

Android App Store).

• Open the Aquascape Smart Control App and click 'Create New Account'.

NOTE: If you already have an account, login with your username and

password.

• Once logged in, click the three dashes

in the upper right-hand corner of the

home screen (Ex. 3).

• Click 'Add New Device' (Ex. 4).

• Enter the Wi-Fi network and password

for the network to which the unit will

connect (Ex. 5).

NOTE: Adequate Wi-Fi coverage is

required (2.4 GHz networks supported).

• Continue to follow on-screen instructions

to complete the pairing process.

• To reset the device to factory defaults,

ﬁ rst turn the unit off by pressing the power

button, then press and hold the + and -

buttons for four seconds and release

when the LED display lights up completely (Ex. 6).

• The receiver includes a switch that allows the pump to be operated in the

two following modes (Ex. 7).

Position 1 - Operated by Aquascape Smart Control App or

remote control

–

Position 2 - Bypass control, and operate at full ﬂ ow-rate

• In the event of a power loss the pump will revert to the last ﬂ ow-rate

setting.

Ex. 6

Troubleshooting

• Device won't pair

– Make sure the outlet is receiving power

– Make sure you have adequate wireless coverage to connect

the device (2.4 GHz networks supported)

– Reset the device to factory defaults

– Make sure the ground-fault circuit interrupter (GFCI) is not tripped

Warranty Information

3 YEAR WARRANTY

Aquascape Smart Control Receiver is guaranteed for three years

from date of purchase. Proof of purchase required. Warranty does not

cover damage resulting from negligent handling, misuse, or lack of care.

Warranty is valid against defect due to material and workmanship only.

Products returned must be cleaned, sanitized, or decontaminated,

as necessary, prior to shipment to ensure that employees will not be

exposed to health hazards in handling said material. All applicable laws

and regulations shall apply. The sole obligation shall be to replace the

defective unit with a suitable replacement unit. Units should be checked

for proper operation prior to returning as defective. No liability for loss

or damage of any nature or kind, whether arising out of or from the

use of the product, whether defective or not defective, is assumed by

Aquascape, Inc. or it's afﬁ liates.

For more information about our company or products, please visit our website at

aquascapeinc.com or call us at US (866) 877-6637 CAN (866) 766-3426

Ex. 3

Ex. 4

Ex. 5

Ex. 7

10/19

10/14/2019 9:28:49 AM