AQUASONIC AC339 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Спікери AQUASONIC AC339. AQUASONIC AC339 10 сторінок. Underwater loudspeakers

AQUASONIC AC339 Посібник з монтажу

GENERAL SAFETY INSTRUCTIONS

!
Thank you for purchasing the Aquasonic® AC339 from Clark Synthesis Tactile Sound. Please read
the following instructions before assembling and using the product.
1.
DO NOT DROP SPEAKER
under warranty.
2.
Do not expose speaker to high distortion levels
speaker shuts down the built-in protection circuit is signaling that the volume level is too high.
Turn the amplifier off for approximately 45 - 90 seconds to allow the TST to reset. Operate at
reduced volume. Continued use of high levels of distortion may fail speaker, which is not covered
under warranty.
3.
Use a ground fault interrupter
electrical shock in the event of a malfunction. These are available at hardware stores or home
improvement stores. They are easy to install and provide a safe operating environment for your
electronics and all pool users.
Place speaker in pool away from diving boards and high activity areas
4.
result if speaker is contacted while diving or jumping.
5.
Cable placement
tangle causing possible drowning or where pets may damage cable.
Do not hang speaker by speaker cable
6.
speaker, and tie other end to a stationary anchor.
7.
Do not drag speaker on pool deck, bottom or side of pool
not covered under warranty.
Do not remove or alter the watertight fitting from speaker housing
8.
factory to seal out water. Over tightening may destroy the water-tight seal. Any physical
alteration or damage will void the warranty.
9.
Avoid Excessive heat
temperatures, as in a closed car, may result in damage and will void the warranty.
The built-in protection circuit
10.
approximately 45 - 90 seconds to allow the speaker to reset. Restart the amplifier at a lower
volume. The protection circuit is triggered by excessive heat, distortion, or being overpowered.
Continued overload of shut down circuit or abuse without correction of system may fail speaker,
which is not covered under warranty. If symptoms persist the system may need to be configured
differently. Contact Clark Synthesis or local dealer for assistance.
1
Aquasonic
- If damage occurs due to high impact of speaker, it is not covered
- A GFI outlet or extension cable on the stereo system will prevent
- Do not place cable in high traffic areas where people may trip or cable may
- Do not leave speaker in direct sunlight unless submerged in pool. High
- If the speaker shuts down, turn the amplifier off for
- Excess distortion may result in failure. If
- Use a tether (nylon rope) tied to the eyelet on the
- This will damage speaker and is
- Severe injury may
- This fitting is set at the