Diamond Antenna D130J Посібник з експлуатації
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Антена Diamond Antenna D130J. Diamond Antenna D130J 1 сторінка. Super discone antenna for wideband reception
Також для Diamond Antenna D130J: Посібник з експлуатації (2 сторінок)
OPERATING MANUAL
D130J/D130NJ Super Discone Antenna for Wideband Reception
The D130J/D130NJ Super Discone Antenna is
the first ultra-wideband antenna in the market
which can cover amateur radio, air traffic
control and other various utility frequency
bands and, in addition, even some amateur
radio frequency bands within the covering
frequency range can be transmitted with this
antenna
alone.
The
D130J/D130NJ
designed to be able to assemble very easily
and can be built in a couple of hours by
beginners.
Rust
free
stainless
employed in major component parts to have
the antenna rust resistant and durable. And its
very compact and lightweight design enables it
to be installed at any convenient place.
Description
1. Ultra-wideband design to be able to cover
25-1300MHz.
2. Very compact and lightweight design
enables the antenna to be installed on
balcony railing at an apartment or
condominium.
3. 6m, 2m 70cm and 23cm amateur
frequency bands and 33cm band
(900MHz) can be transmitted.
4. Since all radial rods are designed to have
the same length, the D130J/D130NJ is
perfectly omnidirectional as original
discone antenna and can receive radio
propagation from any direction evenly.
5. The D130J/D130NJ can be made further
compact and lightweight by removing the
top element assembly, if it doesn't require
to receive lower end frequency range.
Specifications
Frequency range: 25-1300MHz for receiving
only (Amateur frequency
bands and personal radio
frequency band for trans-
mitting)
Length
:1.7m (66.9")
Weight
:1kg (2.2lbs.)
Max. Diameter
: 0.41m (16.1")
Mast diameter accepted: 25-50mm (0.98" to
Max. Power rating: 20W FM (6m), 50W PEP
200W FM (except for 2m)
Type
: Wideband Omnidirectional
discone antenna
Assembling the D130J/D130NJ Super Discone Antenna
・Number below each part name
is a part number
・Coaxial cable is not included.
is
steel
is
Hexagonal wrench
01008
Set screw 01009
Turn set screw until it stops lightly
and then turn it about one and
half turn to fix radial element rod
and to avoid disconnecting the
element.
Filled part of each radial
element rod has to be
set upward.
Each cap has to be
attached to the empty
side of the rod.
2.05")
(6m)
DIAMOND ANTENNA Products are distributed by RF PARTS COMPANY
435 S. Paci c S treet
www.diamondantenna.net
Set screw
01010
Spring washer
01011
Radial
element rod
820mm (32.3")
01005
Nut M5
Nut
Spring
washer
Cap (large)
Screw
01014
Coaxial cable is not included.
San Marcos, CA
920 78
(770) 614-7443
Cap (small)
01015
Top element
01001
Loading coil
01002
Disc element rod 01004
280mm (11.0")
These disk element rods have to be assembled
after radial rods have been assembled.
Nut M4 01016
Apex assembly 01003
After putting apex assembly out from the package,
detach support pipe from the assembly by removing
three M3 screws. Then connect coaxial cable to
coaxial receptacle at the bottom of apex assembly
through support pipe as shown in the illustration.
Screw M3
01013
Lock washers
01012
Support pipe
01020
Applicable mast diameter
25 to 52mm (0.98 to 2.05")
Bracket
V-bolts
assembly
01018