Panasonic WV-NF284 - i-Pro Network Camera Посібник з монтажу - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник з монтажу для Відеокамера. Panasonic WV-NF284 - i-Pro Network Camera. Panasonic WV-NF284 - i-Pro Network Camera 36 сторінок. Ip video cameras
Також для Panasonic WV-NF284 - i-Pro Network Camera: Технічні характеристики (2 сторінок), Брошура (2 сторінок), Посилання (2 сторінок), Посилання (2 сторінок), Порівняльна таблиця (6 сторінок), Технічні характеристики (2 сторінок), Технічні характеристики (2 сторінок), Інтеграційна примітка (8 сторінок)

• When using PoE (Power over Ethernet: IEEE802.3af compliant)

Connect a LAN cable (category 5 or better) between a PoE device (such as a PoE hub) and the

network connector of the camera.

Important:

• Use all of 4 pairs (8 pins) of the LAN cable.

• The maximum cable length is 100 m.

• Make sure that the PoE device in use is compliant with IEEE802.3af standard.

• When connecting both the AC 24 V/DC 12 V power supply and the PoE device for power

supply, PoE will be used for power supply.

• When disconnecting the LAN cable once, connect the cable again after 2 seconds or more

from the disconnection. When the cable is connected before 2 seconds passed, the power

may not be supplied from the PoE device.

• Refer to the provided slip (Recommended network devices for PoE (IEEE802.3af compli-

ant) connection with the WV-NF284) for applicable PoE devices.

Step 3

Connect a LAN cable (category 5 or better)

to the network connector on the mounting

side of the camera.

Step 4

Connect an external device.

q Remove 3 mm – 7 mm of the outer jacket

of the cable from the external device and

twist the core of the power cord to pre-

vent a short circuit.

Approx. 3 mm - 7 mm

Specification of cable (wire):

AWG #16 - #28 Single core, twisted

Network connector

w Loosen the screws of the provided exter-

nal I/O terminals plug and insert the

cables from the external device into the

external I/O terminals plug until the

exposed core wires are completely hid-

den.

External I/O terminals plug

(provided as a standard

accessory)

e Tighten the screws to fix the inserted

cables.

* Make sure that the exposed core wires

are completely hidden after tightening

the screws.