Panasonic WV-SC385 Посібник з монтажу - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник з монтажу для Відеокамера. Panasonic WV-SC385. Panasonic WV-SC385 40 сторінок. Ip video cameras
Також для Panasonic WV-SC385: Технічні характеристики (2 сторінок), Посібник з монтажу (36 сторінок), Посібник з монтажу (40 сторінок), Порівняльна таблиця (6 сторінок), Посібник з монтажу (40 сторінок), Інтеграційна примітка (8 сторінок)
Друкувати сторінку
Wire through a hole in the ceiling
Step 1
Fix the camera mount bracket (accessory) with four
optional fixing screws (M4 or M6, locally procured).
There should be no obstacles such as wall in a range of
100 mm {3-15/16 inches} away from the center point of
the camera mount bracket.
Shooting direction (FRONT)
Step 2
Make a hole in the ceiling to pass the cables through.
Make a hole 25 mm {31/32 inches} in diameter. The cen-
ter point of the hole should be located approx. 75 mm
{2-15/16 inches} away from the center point of the cam-
era mount bracket.
Wiring hole
(ø25 mm {31/32 inches})
16
83.5 mm
{3-9/32 inches}
110 mm
{4-5/16 inches}
100 mm {3-15/16 inches} or more
away from obstacles such as wall
Step 3
Insert the SDHC/SD memory card into the SDHC/SD
memory card slot. Refer to page 26 for how to insert the
SDHC/SD memory card.
Step 4
Attach the safety wire fixed with the camera mount
bracket (accessory) to the camera.
After attaching the safety wire to the camera, confirm that
the ring part at the end of the safety wire is securely
hooked on the safety wire holder.
Screw
(M4)
Screw
(M6)
Step 5
Connect cables to the External I/O terminals, microphone/
line input connector, audio output connector and the
monitor out connector for adjustment. When connecting
these cables, hold the base part of the camera.
Microphone/line
input connector
External I/O terminals
10BASE-T/
100BASE-TX
LINK
Base
part
• External I/O terminals
Connect external devices.
When connecting an external device, remove 9 mm -
10 mm {11/32 inches - 13/32 inches} of the outer jacket
of the cable and twist the cable core to prevent the short
circuit first.
Safety wire holder
Audio output connector
ACT
INITIAL
POWER
EXT I/O
MIC/LINE IN
AUDIO OUT
MONITOR OUT
SET
12V IN
4 3 2 1
Safety wire
Monitor out
connector for
adjustment