Panasonic WV-SF342 Посібник з монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з монтажу для Відеокамера. Panasonic WV-SF342. Panasonic WV-SF342 48 сторінок. Ip video cameras
Також для Panasonic WV-SF342: Технічні характеристики (2 сторінок), Посібник з монтажу (44 сторінок), Особливості та технічні характеристики (2 сторінок), Інтеграційна примітка (8 сторінок)

Друкувати сторінку

Precautions for Installation

Panasonic assumes no responsibility for injuries or property damage resulting from fail-

ures arising out of improper installation or operation inconsistent with this documenta-

tion.

This camera is designed to be used

indoors.

This product is not operable outdoors.

Do not expose this camera to direct sunlight for

hours and do not install the product near a

heater or an air conditioner. Otherwise, it may

cause deformation, discoloration and malfunc-

tion. Keep this camera away from water and

moisture.

Installing place

Do not place this product in the following plac-

es:

• Locations where it may get wet from rain

or water splash

• Locations where a chemical agent is used

such as a swimming pool

• Locations subject to humidity, dust, steam

and oil smoke

• Locations in a specific environment where

a solvent or a flammable atmosphere

exists

• Locations where a radiation, an X-ray, a

strong radio wave or a strong magnetic

field is generated

• Locations where corrosive gas is pro-

duced, Locations where it may be dam-

aged by briny air such as seashores

• Locations where the temperature is not

within –10 °C to +50 °C {14 °F to 122 °F}.

• Locations subject to vibrations (This prod-

uct is not designed for on-vehicle use.)

• Locations subject to condensation as the

result of severe changes in temperature

(In case of installing the camera in such

locations, the dome cover may become

foggy or condensation may be caused on

the cover.)

Be sure to remove this product if it is not

in use.

Shielded (STP) LAN cables must be used

with this unit to ensure compliance with

EMC standards. *

* PAL models only

Before installation

• The camera mount bracket described on

page 21 shall be used to mount the cam-

era.

• When this camera and camera mount

bracket are mounted on a ceiling or a wall,

use the screws described on page 21. The

screws to be used are not provided.

Prepare the screws according to the mate-

rial, structure, strength and other factors of

the mounting area and the total weight of

objects to be mounted.

• Ensure that the mounting surface, anchor

and screws are sufficiently strong.

• Do not mount this product on a plaster

board or a wooden section because they

are too weak. If this product is unavoidably

mounted on such a section, the section

shall be sufficiently reinforced or use a ceil-

ing mount bracket WV-Q105* (option).

* PAL models only

Screw tightening

• The screws and bolts must be tightened

with an appropriate tightening torque

according to the material and strength of

the installation area.

• Do not use an impact driver. Use of an

impact driver may damage the screws or

cause tightening excessively.

• When a screw is tightened, make the

screw at a right angle to the surface. After

tightening the screws or bolts, perform

visual check to ensure tightening is enough

and there is no backlash.