Panasonic WV-SP509 Посібник з монтажу - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з монтажу для Відеокамера. Panasonic WV-SP509. Panasonic WV-SP509 36 сторінок. Ip video cameras
Також для Panasonic WV-SP509: Специфікація (2 сторінок), Посібник з монтажу (40 сторінок), Інтеграційна примітка (8 сторінок)

Друкувати сторінку

Lens mounting

Slowly rotate the lens clockwise to mount the lens and connect the lens cable to the ALC lens con-

nector of the camera.

ALC lens connector

Optional dedicated lens

Product name

ALC lens for 1/3 type CCD cameras

2x varifocal (High resolution)

* If a lens for 1/3 type video camera other than the above is mounted and the camera is used at

resolution of 1280 x 720 or higher, the camera cannot achieve full performance of high resolu-

tion. It is recommended to use a dedicated high-resolution lens especially when the illuminance

level of the photographic subject is low and the camera is used with the lens iris open.

How to adjust the focus

Before adjustment, reset the back focus position by holding down the auto back focus button

for 5 seconds or more when the power is on. (This operation can also be performed on the

setup menu. Refer to the Operating Instructions (included in the CD-ROM).)

Adjust the view angle and focus coarsely by adjusting the zoom and focus of the lens to center

a subject in the screen, and then press the auto back focus button on the side of the camera

(☞ page 16) or perform the auto back focus function from the setup menu.

Refer to the Operating Instructions (included in the CD-ROM) for how to perform the auto back

focus function from the setup menu.

IMPORTANT:

• Press the auto back focus button twice quickly to perform basic adjustments in a short time.

For more accurate adjustments use the detailed adjustments.

• After performing basic adjustments, make sure to press the auto back focus button once to

perform detailed adjustments.

Zoom lock knob

CS-mount lens

(option)

Focus ring

Model number

WV-LZA62/2

Protruded portion

from mount face:

ø20 mm {25/32

inches} or less

4.5 mm {5/32 inches} or less

1 3

Pin No.

2 4

Dump

Drive