Diamond Antenna V2000A Інструкція - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція для Антена Diamond Antenna V2000A. Diamond Antenna V2000A 4 сторінки. 6m/2m/70cm triband base antenna

Друкувати сторінку

Diamond Antenna Products

frequency (see tuning chart below figure 7).

6. Before final installation, check VSWR on 2m & 70 cm. (No adjustment is

possible on these two bands.)

7. Attach mast brackets to Antenna Support Pipe. Pass the coaxial cable

through the bottom of the Antenna Support Pipe. Connect coaxial cable to

the feed point (figure 5). Align hole on Antenna Support Pipe with threaded

hole at bottom of antenna. Insert screw with lock washer and tighten (figure

5).

8. Attach antenna to antenna mast using brackets and hardware kit (figure 6).

We suggest mounting one turn of coaxial cable of approximately 10"

diameter directly beneath the antenna. This will act as an isolation choke. The

coil diameter is not critical—Note: Some cable require a larger diameter coil

to prevent movement of center conductor. Tape coil to mast (figure 6).

http://www.rfparts.com/diamond/v2000tech.html

Side 2 av 4

09.08.02