Panasonic 42PWD8UK - 42" Plasma Panel Інструкція з експлуатації Посібник з експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для ТЕЛЕБАЧЕННЯ Panasonic 42PWD8UK - 42" Plasma Panel. Panasonic 42PWD8UK - 42" Plasma Panel 48 сторінок. Progressive wide plasma display

Panasonic 42PWD8UK - 42
Connections

PC Input Terminals connection

Notes:
• Due to space limitations, occasionally you may have trouble connecting D-sub 15P cable with ferrite core to PC input
Terminal.
• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 640 × 480 dots (TH-37PWD8UK, TH-42PWD8UK), 768 × 720 dots (TH-37PHD8UK),
768 × 768 dots (TH-42PHD8UK), 1,024 × 768 dots (TH-50PHD8UK) when the aspect mode is set to "NORMAL", and 852
× 480 dots (TH-37PWD8UK, TH-42PWD8UK), 1,024 × 720 dots (TH-37PHD8UK), 1,024 × 768 dots (TH-42PHD8UK),
1,366 × 768 dots (TH-50PHD8UK) when the aspect mode is set to "FULL". If the display resolution exceeds these
maximums, it may not be possible to show fi ne detail with suffi cient clarity.
• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the D-sub 15P Connector.
Signal Names for D-sub 15P Connector
11
12
13
14
15
6
7
8
9
10
1
2
3
4
5
Pin Layout for PC Input
Terminal
10
COMPUTER
Conversion adapter
(if necessary)
Connect a cable which matches
the audio output terminal on the computer.
Pin No.
Signal Name
R (P
1
G (Y)
2
B (P
3
GND (Ground)
4
GND (Ground)
5
TH-42PWD8
RGB
PC cable
Audio
Pin No.
Signal Name
/C
)
GND (Ground)
6
R
R
GND (Ground)
7
/C
)
GND (Ground)
8
B
B
NC (not connected)
9
GND (Ground)
10
AUDIO
PC IN
D-sub 15p
Stereo plug
Pin No.
Signal Name
GND (Ground)
11
12
HD/SYNC
13
14
15
SDA
VD
SCL