Panasonic CT-27D20U Інструкція з експлуатації Посібник з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для ТЕЛЕБАЧЕННЯ Panasonic CT-27D20U. Panasonic CT-27D20U 21 сторінка. 36" diagonal stereo monitor-receiver
Також для Panasonic CT-27D20U: Посібник з експлуатації (44 сторінок), Інструкція з експлуатації Посібник з експлуатації (44 сторінок)
INSTALLATION
Installation
Television Location
This
unit
is intended
to be
used
with an optional
stand
or entertainment
center.
Consult
your dealer
for available
options.
E3 Avoid excessive sunlight or bright lights, including reflections.
I_
Keep away from excessive
heat or moisture.
Inadequate
ventilation
may cause internal
component
failure.
E3
Fluorescent lighting may reduce remote control transmitting
range.
E3
Keep away from magnetic equipment,
including motors, fans and external speakers.
Optional Cable Connections
Shielded
audio
and
video
cables
should
be used
between
components.
For
best
results:
El
Use 75-ohm coaxial shielded cables.
1_
Use appropriate
input and output connectors,
that match your component connectors.
I_
Avoid long cables to minimize interference.
AC Power Supply Cord
CAUTION:
TO PREVENT ELECTRIC
SHOCK MATCH WIDE BLADE OF PLUG TO
WIDE SLOT OF AC OUTLET AND FULLY INSERT.
DO NOT USE A PLUG WITH A
RECEPTACLE
OR
OTHER
OUTLET
UNLESS
THE
BLADE
CAN
BE FULLY
INSERTED
TO PREVENT
BLADE EXPOSURE.
FOR SOME MODELS
THAT ARE
NON-POLARIZED,
THE USE OF AN AC ADAPTOR
CONNECTOR
MAY
BE NECESSARY.
Cable / Antenna Connection
For proper
reception,
either
a cable
or antenna
connection
is required.
Cable
Connection
Connect
the cable supplied
by your local cable company.
Note:
A cable converter box may be required for proper reception. Check with
your local cable company for compatibility requirements.
Antenna Connections
t'l
For proper reception of VHF/UHF
channels, an external antenna is
required. For best reception an outdoor antenna is recommended.
D
Antenna Mode must be set to IV.
--_
Cable
Preset
Cable Mode is preset at the factory. Antenna
I
users must change to Antenna Mode in the
Setup Menu,
Polarized plug
,ll I
Non-Polarized
plug
Incoming
Cable from
Cable Company
75 Ohm VHF/UHF
on back of TV
Incoming Cable from
Home Antenna
Iii