Diamond Audio DES Series Посібник користувача - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник користувача для Сабвуфер Diamond Audio DES Series. Diamond Audio DES Series 20 сторінок.
Також для Diamond Audio DES Series: Посібник користувача (4 сторінок)
Друкувати сторінку
SYSTEM SETUP
4.TURN-ON MODE OPTIONS - Configure the "Turn-On Mode" switch for desired turn-on trigger. There are 3 modes available
on the DES series amplifier, REM, DC and VOX. 1 - (REM) is the standard 12V trigger wire, 2 - (DC) or DC offset, when
connected high level in, will sense differences in ground in your wiring through the speaker leads and turn on amplifier,
3 - VOX (signalsensing) will sense signal input into the amplifier RCA INPUT turning on the amplifier. DIAMOND AUDIO
Bluetooth Controller. The most preferred and reliable method is using the REM setting with a 12V trigger wire connected
to the vehicles ignition and will provide instant on and off for the amplifier. VOX and DC will provide turn on capabilities
for the amplifier when a 12V trigger wire is not available. These methods will have some delay in turning the amplifier
on and off.
"SWITCHED"
12 VOLTS
DC "OFFSET"
5. REMOTE LEVEL/REMOTE LEVEL "SLAVE" – These RJ11 ports are specifically designed to be used with the DIAMOND
AUDIO BASS REMOTE controller. This will allow direct plug in control (level)of the subwoofer output. It is a proprietary
design and can ONLY be used with Diamond Audio amplifiers. This controller allows the user to adjust the subwoofer
level control totally seperate from the bass EQ that is in your car audio source unit. It is a GAIN control that specifically
controls the subwoofers level from 0 to +12dB more GAIN. Be careful as this will cause distortion at high levels as no
car audio amplifier has 12 dB of gain (this is equivalent to 20 times more power output DEMAND when the Remote
Bass knob is turned all the way up - clockwise) Assuming you have a 1,000 watt monoblock (like a DES1000.1D) you
would be asking the amplifer to produce 20,000 watts for a brief period of time. Also with our DES500.1D and
DES1000.1D there is an additional RJ11 Remote Bass Slave Port (See below). This makes using 2 DES monoblock
amplifiers subwoofer level adjustment simple using only ONE (1) Remote Bass Control. See below:
PASS THRU from
"MASTER" AMP
Remote Bass
Control
INPUT from
HeadUnit (sub out)
DES500.1D/DES1000.1D
To Sub
6 pin RJ11 cord
DES500.1D/DES1000.1D
To Sub
"VOX" VOICE
ACTIVATED
(signal sensing)
"SLAVE"
"MASTER"
11