Diamond Audio D7152 Довідковий посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Довідковий посібник для Підсилювач Diamond Audio D7152. Diamond Audio D7152 11 сторінок. Professional reference series amplifier

Друкувати сторінку

SPEAKER WIRING

Diamond Audio recommends using speaker wire of at least 16 gauge.

Lay out the wire in the vehicle from the individual speaker locations to the

amplifier(s). Observe safe wiring precautions.

Your D7 Professional Reference Series Amplifier will accept speaker wire

up to 10 gauge directly. Locate the speaker terminal block on the end of the

amplifier. Strip approximately 1/2 inch of insulation from the wire, insert

the wire into the terminal, and tighten the Allen screw. Repeat for all speaker

wires. Please observe our recommended minimum speaker impedances to

prevent possible damage.

Banana Jacks using up to 8 gauge wire can be inserted into the speaker block.

Remove the set screw completely and insert the Banana Jack into the end of

the block.

CROSSOVERS

All Diamond Audio D7 amplifiers employ the most flexible internal crossover

sections currently available in mobile audio. They feature third-order 18dB/

octave Butterworth filters. These filter networks sum to a flat response at their

-3dB break points. This results in a smooth and seamless transition from one

frequency band to the next. Butterworth filters provide maximally flat

frequency responses when compared to other filter structures.

All crossover controls are mounted on the top of the amplifier. Each crossover

is continuously variable from 50Hz to 5kHz. Each pair of channels has an

individual network that can be configured to Highpass, Lowpass, Bandpass or

All-pass by simple switch selection. When switched off, they are completely

out of the audio path.

Two and four-channel D7 amplifiers also provide a separate fully-

independent crossover for the output RCA jacks providing filter control of

any other amplifier.

THERMAL MANAGEMENT SYSTEM

All D7 Professional Reference Series Amplifiers feature our Intelligent Thermal

Management System. All amplifiers feature one or two (depending

on model) internally mounted temperature-controlled cooling fans.

Care should be taken to allow adequate "breathing room" (approximately

2 inches) on all sides of the installed amplifier to allow the system to operate

at peak efficiency.

Cool outside air is drawn into the amplifier through the side vents on each

end panel. The air is then drawn over the top of the main circuit board, down

through the fan over the internal heat sink fins (in two directions) and out

through exhaust vents on the bottom of each end panel. In this way, the

cooling fan(s) remain nearly inaudible under almost all listening conditions.

When D7 amplifiers operate at high power for prolonged periods, the

temperature sensors instruct an intelligent monitoring circuit to speed up the

fan(s) until the amplifier has cooled down to its normal operating temperature.

Amplifier models D7402 and D7104 also feature our unique Power-Flow

Busbar. The shroud connecting and covering the two internal cooling fans of

these amplifiers is made of solid nickel-plated copper. Each end of this fan

shroud is soldered to full width pads on the main circuit board. The center

of this shroud is attached to the fans at eight points. The high current ground

path for the speakers now travels over the cooling fans through the shroud,

which functions as a busbar. At the same time, these high current signals are

completely isolated from the circuit board traces that carry low-level signals.