AquaStar Ultimate Ozone U3000 Kit Посібник з встановлення та експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Освітлювальне обладнання AquaStar Ultimate Ozone U3000 Kit. AquaStar Ultimate Ozone U3000 Kit 6 сторінок. Ozone generation system

Друкувати сторінку

SECTION 3. Operation

Initial System Start-Up
Upon completing installation you may be ready to
begin start-up procedures.
1. Ensure water level is appropriate for normal
skimmer operation.
3. Ensure that the 1/4'' ozone compatible tubing
is connected securely to the 1/4'' Hose Barb
Outlet Fitting(s).
3. Turn on circulation pump.
4. Check that the electrical outlet to be used is an
approved 120V GFCI outlet. Plug the ozone
generator into outlet.
5. Check for normal operation, see below.
Normal Operation
Upon plugging in the Ultimate Ozone™ the system
will turn on and begin producing ozone. The unit
may generate a quiet hum, this is the sound of the
air pump operating. Inspect the FlowStar™ ozone
compatible skimmer, small bubbles should begin to
emerge from the bubble plate located in the throat
of the skimmer.
Water Chemistry
Regular chlorine or bromine testing should be
performed to assure proper sanitizer residual is
present in the pool or spa as normal. Ozone will be
eliminating the majority of contaminants.
Therefore, only a small amount of sanitizer will
need to be added – just enough to maintain a
minimum of residual level of 1.0 ppm chlorine or
1.0 ppm bromine. Maintain pH between 7.2 and 7.8.
Note 1: The U.S. EPA has established a maximum
chlorine level of 4.0 ppm for re-entry of swimmers
into pool or spa water.
Note 2: Bromine shall not exceed 8.0 ppm (As Br
when bathers are present.
Ultimate Ozone™ Installation and User's Guide
Maintenance
The Ultimate Ozone™ requires little maintenance. For a
properly prerforming system, ensure that the
skimmer basket is regulary checked and kept clean
from excess debris. Every month all visual
components should be inspected. If anything is found
to be damaged it should be replaced.

SECTION 4. Troubleshooting

Knowledge of electrical applications is required for
troubleshooting. Contact a certified electrician if you
are unsure of your ability to service the equipment.
Improper servicing or opening the
Ultimate Ozone
Symptom: Ozone output has dropped.
No power to the generator module from the power
supply:
a. Unplug unit and check fuse located at the
bottom of the Ultimate Ozone
b. Check cables for breaks or loose connections,
replace if necessary.
Symptom: No air flow through the generator.
1. Check to see if ozone unit is getting proper power.
2. Air compressor is not operating properly.
a. Listen for the slight hum of the air compressor.
b. Check all tubing connections from the air
compressor through the system for leaks.
3. Ozone compatible tubing damaged.
a. Check tubing for blockage, kinks, or leaks.
Symptom: Large bubbles coming from skimmer
bubble plate.
1. Ozone diffuser stone is worn, damaged, missing or
disconnected.
a. Replace Ozone diffuser stone, part #OZG4017

Contact Information

)
2
Visit: www.aquastarpoolproducts.com
casing will void warranty.
TM
TM
For Technical Assistance:
Call: 877-768-2717
4
unit.
Rev: 030717