Diamond Audio Technology D5 5.1 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Автомобільний підсилювач Diamond Audio Technology D5 5.1. Diamond Audio Technology D5 5.1 17 сторінок. Professional reference series amplifier

Друкувати сторінку

BASIC TROUBLESHOOTING

Amplifier has no output.

Is LED (located on power/ground endpanel) lit?

Yes: Make sure audio signal is present at RCA inputs. If no signal is

present, use alternate signal source and try again. If signal is

present, check configuration of crossovers. If still no signal, contact

your authorized dealer.

No: Check power, ground and remote wire for +12V. Verify all

connections. If voltages are correct and still no LED, contact your

authorized dealer.

Note: The following steps apply to each pair of channels on your amplifier.

Sound in one channel only.

Swap RCA cables at amplifier inputs. Is the sound now in the

opposite channel?

Yes: Reverse the input RCA cables in every product installed BEFORE

your amplifier until the problem is found. Check RCA cables for

open connections. Repair as necessary.

No: Check the speaker or speaker wires of the dead channel and

repair as needed. If speaker and wire are OK, contact your

authorized dealer.

One or one of the pairs of amplifier channels "squeal" when

operating.

One or more speaker wires are shorted or one or more speaker

voice coils are shorted or rubbing. If speakers and wires are OK,

contact your authorized dealer.

Amplifier volume cuts out or gets softer as music is playing

without touching any system controls.

Amplifier is going into thermal protection. Make sure amplifier has

room to breathe. Preventing air from reaching the heatsink will

cause the amplifier to overheat, as will running the amplifier at too

low of an impedance. A fan can be added to aid in ventilation.

Individual Channel Cuts Out.

Channel is going into protection. Check speaker wire for any shorts

and check that speaker is not blown. Also check the load on the

channel to make sure it is not to low.

Diamond Audio Technology 10