Diamond Audio Technology D7401 Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник з монтажу для Автомобільний підсилювач Diamond Audio Technology D7401. Diamond Audio Technology D7401 11 сторінок.
Друкувати сторінкуCONTINUOUS RMS OUTPUT POWER
Note: Full Rated Power is generated at all voltages between 11 and 16VDC.
D7401
400W x 1 @ 4 Ohm Stereo
800W x 1 @ 2 Ohm Stereo
(minimum impedance)
CROSSOVER SPECIFICATIONS
Quantity:
2 (1 for CH 1 INPUT & 1 for X-OVER OUT)
Type:
Fully Independent and Selectable Highpass,
Lowpass, Bandpass or All-pass.
Slope:
Third Order 18dB/Octave Lowpass & Subsonic
Third Order 18dB/Octave (AUX)
Alignment:
Butterworth
FUSE RECOMMENDATIONS
D7 Professional Reference Series Amplifiers, by design, require external fusing.
Research has shown that a circuit board mounted fuse can create a drop in
available DC voltage at the input of the power supply resulting in increased
current draw.
We recommend that you install the correct size fuse/holder combination to the
main power cable within 18 inches of the battery. This will protect your vehicle
from fire damage due to a short circuit to the chassis or vehicle body. If a single
amplifier is installed, follow the fuse recommendation below. If installing
multiple amplifiers, add up the total fuse ratings of all installed amplifiers. This
should be used as your main fuse rating.
Amplifier
D7401
Note: A main fuse must be installed within 18 inches of the positive
battery terminal.
2
Maximum Fuse Rating
80 Amps
SYSTEM DIAGRAM 3
Three Way System with
Dual 2 Channel Amplifiers
and D7401
D7 two channel amplifiers
Left amp bridged Highpass to left components
?
Right amp bridged Highpass to right components
?
D7401
Lowpass to a pair of 4 Ohm woofers
?
19