AQUASYSTEM APDS Series Посібник з експлуатації та обслуговування - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з експлуатації та обслуговування для Водяний насос AQUASYSTEM APDS Series. AQUASYSTEM APDS Series 10 сторінок.
USAGE INSTRUCTION
Fix the adapter firmly to drum can's larger ajutage (outlet, G2). [Drawing 1]
①
Release the Push Screw and insert the pipe into the adapter until you can't
②
insert it any further. [Drawing 1]
Manually tighten the Push Screw. [Drawing 1]
③
Insert into the smaller ajutage (outlet, G3/4): the regulator (for delivery) or
④
the ejector (for suction). Fix it firmly. [Drawings 2 & 3]
Close the air valve by setting it perpendicularly to the hi-coupler 20PM.
⑤
[Drawings 2 & 3]
Close the suction/delivery valves [A] & [B] by setting them perpendicularly to
⑥
the hose. [Drawings 1 & 4]
[Delivery only] Close the adapter's P-cock. [Drawing 1]
⑦
Connect the compressor to hi-coupler 20PM. [Drawings 2 & 3]
⑧
Open the air valve – the compressed air enters the can (below 1 MPa).
⑨
[Delivery only] Make sure the pressure (measured by the meter) is stabilized
at 0.05 MPa (0.5 kgf/cm
). [Drawing 2]
2
Opening suction/delivery valves [A] & [B] begins suction/delivery.
⑩
[Delivery]
⚫
When the liquid in drum can runs out, the air will come out of a delivery line.
[Suction]
⚫
When the liquid fills the can full, the float ball will block the suction line.
The suction will automatically stop. [Drawings 1 & 4]
Closing the suction/delivery valve [B] stops suction/delivery. [Drawing 4]
⑪
After use, close the air valve and suction/delivery valve [A]. Open the
⑫
suction/delivery valve [B] to let out the leftover liquid from the hose. After
that, close the suction/delivery valve [B]. [Drawings 1 & 4]
[Delivery only] Open the adapter's P-cock to restore normal pressure in the
⑬
drum can.
Leftover pressure may be very dangerous. It may splash the liquid and
⚫
push the pump out of the can. Make sure the pressure meter shows "0".
Please use a ground wire for protection against fire and explosion.
⚫