3Built RES126VX Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Автомобільні аксесуари 3Built RES126VX. 3Built RES126VX 3 сторінки. Remote engine shut-off
Також для 3Built RES126VX: Інструкція з монтажу (5 сторінок), Посібник із швидкого старту (9 сторінок)
Друкувати сторінку
INSTALLATION INSTRUCTIONS
WARNING
BY INSTALLING OR USING THIS PRODUCT YOU AGREE TO OUR "END USER AGREEMENT". IT IS INCLUDED WITH
THESE INSTRUCTIONS AND AVAILABLE ON-LINE AT http://www.3built.com/documents.asp
Use of this product could result in injuries to the rider due to the sudden loss of engine power. Motorcycles and ATV's
may lose stability when engine power is disabled. Control of the vehicle will also be limited after engine is disabled. This
product will not stop a vehicle. It will not apply the brakes or any other mechanism to reduce speed. It is designed to
disable the engine by shutting off the ignition system. It functions similarly to the vehicle's stock (OEM) STOP/RUN
switch. Use extreme caution as to when and where the vehicle is before disabling the engine. Proper judgment must be
used when disabling engine power. Performance and range is not guaranteed. Radio frequency interference may be
common in some areas. Use of motorcycles, ATV's and other motor vehicles is an inherently dangerous activity. Wear
proper protective gear when operating the vehicle. If any doubt of potential injury, do not use. Once installed, to
understand how this product functions, test the device by disabling the vehicle's engine, first at idle and then at low speed.
This product's installation and use is at your own risk. This product is intended to be installed and used by adults only.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
INCLUDED PARTS
GETTING STARTED
**IMPORTANT
– This unit will
1) Installation of this device requires electrical and electronics knowledge.
2) You should have a wiring diagram for your vehicle before installation. This is available from your dealer in the Repair
Manual for your vehicle. Some vehicle specific wiring instructions are available on our website at:
https://3built.com/pages/support
3) Do not connect any Receiver
4) This device is a remotely activated switch. The switch can be connected as a normally-open or normally-closed switch
while the vehicle is in the RUN mode. The internal relay is limited to switching 8 amperes, maximum.
5) It is important to determine your OEM (original equipment manufacturer) RUN/STOP switch type before installation.
Improper installation of this unit can damage your vehicle's electrical system and CDI. If unsure, please consult a
professional.
6) DEFINITIONS
OEM - Original Equipment Manufacturer. This is any component that the vehicle originally came equipped with from
the factory.
RES - 3Built's Remote Engine Shut-off kit
Normally-open - means that the switch is open (no connection) when the RES is in the unlocked mode. This
connection type is typically used for ground type OEM RUN/STOP switches.
Normally-closed - means that the switch is closed (connected) when the RES is in the unlocked mode. This
connection type is typically used on positive voltage type OEM Run/Stop switches.
©2023 3Built LLC
shut down
after 12 hours of no use, by default. Power cycle to reset. See step #12.
(A)
wire to a high voltage spark plug wire.
Page 1 of 3
Remote Engine Shut-Off
RES126VX & RES126VXE
May 11, 2023